Nagaoka - JN-P110 Replacement Stylus for MP-110

The genuine Nagaoka replacement stylus for the MP-110 and MP-110H — a new diamond, cantilever and suspension for a fraction of a new cartridge.

The MP series is built so that the part which wears is the part you replace. The JN-P110 is not simply a diamond: the assembly carries the stylus, the cantilever and the suspension components, which between them do most of the work of following the groove. A genuine replacement restores the cartridge to the performance Nagaoka designed rather than approximating it.

This assembly carries the MP-110's 0.4 × 0.7 mil bonded elliptical diamond on an aluminium-alloy cantilever and tracks at 1.5 to 2.0 g. It pushes on and pulls off by hand, with no realignment and nothing disturbed in your overhang or azimuth.

Aftermarket styli exist for these cartridges. They are not built by Nagaoka, and their tip geometry, cantilever and suspension compliance are not the ones the MP-110's generator was designed around. This is the factory part.

Features

• Genuine Nagaoka replacement stylus assembly for the MP-110 and MP-110H
• Includes the stylus, cantilever and suspension — not just the diamond
• 0.4 × 0.7 mil bonded elliptical diamond on an aluminium-alloy cantilever
• Fits by hand; no realignment required
• Made in Japan by Nagaoka

Specifications

• Fits: Nagaoka MP-110 and MP-110H
• Stylus: 0.4 × 0.7 mil bonded elliptical diamond
• Cantilever: Aluminium alloy
• Tracking Force: 1.5 – 2.0 g (as specified for the MP-110)
• Origin: Made in Japan
• Stylus Life: Nagaoka's general dealer guidance is a replacement reference time of roughly 150 to 200 hours for typical home use. This figure does not appear on Nagaoka's current product pages and should be read as a rule of thumb, not a specification
• Not Published: Nagaoka publishes no separate specification sheet for the JN-P replacement styli; the figures above are those of the parent cartridge